HMC DHCP and IP subnets

TheDogBoy · #1 February 23rd, 2007

I cannot seem to find any docs on which subnet to use when configuring ent0 as DHCP the first choice is 192.168.128.2 - 192.168.254.255
This would be the subnet I would normally use but can we use any of the other ones? like 10.0.0.2 - 10.0.0.254

Confused...

rzs0502 · #2 February 25th, 2007

Hi,

You could use any of the given options. I believe it's there to give us other options if we are already using any of the subnets on our LAN's or VLAN's
In my old environment, the HMC's and Managed Systems were on a VLAN where 192.168 wasn't allowed, so I changed them.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
HMC Initial Setup	pkosch	Hardware Management Console	11	August 24th, 2007 14:04
HMC Recovery	TheDogBoy	pSeries - System p	9	March 26th, 2007 13:21
Dual HMC connection to P570	eraserhead	Hardware Management Console	4	November 3rd, 2006 10:39
Using an external DHCP for HMCs	m_seger	Hardware Management Console	1	October 19th, 2006 07:57
HMC DHCP leases	edtrumbull	Hardware Management Console	4	June 26th, 2006 14:47

	pSeries Tech Talk Forums Virtualization for POWER Systems Hardware Management Console
HMC DHCP and IP subnets Discuss HMC DHCP and IP subnets on the 'Hardware Management Console' forum of pSeriesTech.org. Talk about HMC DHCP and IP subnets with the IBM pSeries Technical Support Community.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Our Sponsors

Want to advertise?